Beginner
-
Sovol SV08 first print walkthrough: slicing and sending your first job
Install Sovol’s OrcaSlicer build for the SV08, pick the right printer and filament presets, and send your first print over the WiFi connection set…
-
Sovol SV08 unboxing and first setup: from crate to first connection
Position the Sovol SV08’s CoreXY flying gantry with room to move, power it on, check the firmware version, and connect to WiFi so Mainsail…
-
QIDI Q2 error and alert code index
What QIDI has documented so far for Q2 error and alert conditions, what triggers each one, and how to clear it.
-
QIDI Q2 slicer and printer-profile setup for Klipper, OrcaSlicer and PrusaSlicer
Set up QIDI Studio on the QIDI Q2, from first launch through slicing and sending a print, and see why its Klipper firmware also…
-
How to load, unload and change filament on the QIDI Q2
Load filament into the QIDI Q2 with the automatic or manual method, then unload it and swap in a new spool through the printer’s…
-
QIDI Q2 first print walkthrough: from QIDI Studio to a finished plate
Set up QIDI Studio for the Q2, load a model, match the printer, filament and process presets, and slice and send your first print.
-
QIDI Q2 unboxing and setup: from the box to a leveled bed
Unbox the QIDI Q2, clear its transport screws and foam, connect the touchscreen and filament tubes, and let the printer run its first automatic…
-
Flashforge AD5X error code index
A guide to common Flashforge AD5X error codes, split into general printer faults and IFS color-change errors, starting with the simplest fixes first.
-
Flashforge Adventurer 5M error code index
A quick-reference guide to common Flashforge Adventurer 5M error codes, starting with simple checks to try before assuming a hardware fault.
-
Orca-Flashforge slicer setup for multicolor AD5X printing
How to set up Orca-Flashforge for the AD5X, choose the correct printer profile, configure the four IFS filament slots, and pick safe speeds for…
